Intolog Workchair PU 200

Intolog PU 200 Industrial Polyurethane Chair – built for demanding shifts

On a busy production floor, a chair is part of the tooling. The Intolog PU 200 industrial polyurethane chair is designed for use as a warehouse chair at packing stations, as a factory chair on assembly lines and as a workshop chair in maintenance areas. Every detail serves reliability and posture: a supportive seat and back in integral polyurethane (PU), a rigid yet light aluminium base, stable glides as standard and quick gas‑lift height adjustment from 540–730 mm.

Ergonomics

The seat and backrest are moulded from integral PU foam in a single, hard‑wearing piece. Integral polyurethane combines a resilient skin with a slightly softer core, so the surface resists wear and is easy to wipe clean while the structure flexes enough to follow the user’s movements. Rounded front edges reduce pressure on the thighs to keep circulation moving when you sit for extended periods. The backrest tilt is stepless, allowing you to fine‑tune the support to your lower back instead of locking into a few preset angles. Together these features make the PU 200 an ergonomic industrial work chair that helps the body stay aligned during assembly, inspection and packing work.

Because PU is non‑porous and tough, it does not absorb oils or lubricants and is not bothered by the odd hot particle from welding operations nearby. In mixed production environments where metalworking is done next to electronics assembly, this polyurethane work chair simply wipes down between shifts.

Stable aluminium base

The five‑star base is cast from aluminium for a high strength‑to‑weight ratio. Aluminium resists corrosion and keeps the chair easy to move when you need to reposition it, yet it feels planted once you are seated. Delivered on glides as standard, the chair remains steady during lateral reaches and when you pull components across a bench. Glides also make sense where safety dictates that the chair should not roll.

Fast height adjustment

The PU 200 uses a gas‑lift with a generous height adjustment range of 540–730 mm, covering both low packing benches and high, height‑adjustable worktops. The control lever is easy to find and operate, even with gloves, so each user can set an appropriate posture in seconds. This range also supports sit‑stand rotation for tasks that benefit from positional variation.

Correct height is the foundation for comfort. With the hips at or slightly above knee level and feet placed flat, the spine can settle into a neutral curve and the shoulders relax.

Cleanability

Industrial seating earns its keep by staying in service. The integral polyurethane surfaces of the Intolog PU 200 are non‑absorbent and smooth, which means most contaminants wipe off with a damp cloth. There are no fabric covers to replace and no foam pads to saturate. The aluminium base does not rust, so humidity and occasional wash‑downs are not a problem. Over the long term, organisations value equipment that survives hard use without constant attention. This industrial polyurethane chair’s combination of impact resistance, tolerance to oils and lubricants, and mechanical simplicity results in fewer surprises and a lower total cost of ownership. It is seating you can specify once and rely on for years, even in high‑turnover environments.

Specification

• Product: Intolog PU 200 industrial polyurethane chair
• Seat and back: integral polyurethane (PU), black, wipe‑clean
• Base: aluminium five‑star
• Feet: glides (standard); castors available
• Height adjustment: 540–730 mm, gas‑lift
• Backrest: stepless tilt for lumbar support
• Edge profile: rounded front edge to reduce thigh pressure
• Use: warehouses, assembly and packing, workshops, maintenance areas