Corner Collision Barrier

90° Corner Protection Barrier – steel impact protection for high-risk corners

When traffic runs close to walls and machines, corners take the punishment first. A tight forklift turn, a pallet truck that cuts the line, or a reverse into a bay is all it takes. One knock turns into chipped paint, damaged concrete and repairs that keep coming back. This corner protection barrier is built for those everyday risk points in warehouses, production areas and loading zones.

The 90° layout is the big advantage. Instead of shielding only one side, the barrier protects the corner from two directions at the same time. One unit can cover a full corner area, with a clean installation that still keeps routes open for vehicles and pedestrians.

Why a 90° corner barrier makes a difference

The highest collision risk is rarely in the middle of an open floor. It is where traffic changes direction: end-of-aisle turns, corners at loading docks, and tight pinch points between machinery and walls. Sight lines are limited and turning space is tight. A 90° corner protection barrier adds a physical buffer that helps prevent direct hits to structures and equipment.

Because the barrier covers two sides, it is a practical choice for building corners, protective corners around machine installations, and vulnerable areas close to vehicle routes. Used in the right places, it also supports clearer separation between traffic areas and protected zones.

Heavy-duty welded steel for demanding environments

The barrier is made from steel with a fully welded frame, intended for tough day-to-day use where contact can happen. The rigid construction is designed to handle impacts from heavier site traffic such as forklifts and pallet trucks. The hoop shape keeps the protected corner accessible for cleaning and maintenance, without creating sharp edges or complicated fittings.

A steel corner collision barrier is often selected for targets that are expensive to repair or critical to keep running: structural columns, building corners, machine frames and sensitive control areas where downtime is not an option.

Hot-dip galvanised and powder coated for long service life

Moisture, temperature changes, wash-down routines and occasional chemical splashes all shorten the life of untreated steel. This corner protection barrier is hot-dip galvanised and then finished with an additional powder coated surface to help protect against corrosion and wear.

That combined finish makes it suitable for indoor use and outdoor installation, for example on exposed corners at loading docks. It is also built to cope with repeated contact and routine cleaning, helping the barrier keep its protective function and appearance over time.

High-visibility yellow and black hazard marking

Impact protection works best when it is clearly seen. The yellow finish with black markings is a familiar industrial warning colour scheme, easy to spot in busy aisles and dimmer storage areas. Better visibility helps drivers hold a cleaner line and can reduce near misses around corners, posts and equipment.

Where pedestrian routes run close to vehicle lanes, high-visibility barriers also help communicate where vehicles are expected to travel and where extra caution is needed.

Choose the right size

A low barrier can be enough to protect a vulnerable corner from pallet trucks, while a taller barrier gives more coverage in areas with forklift traffic. This 90° corner protection barrier is available in four size options, so you can match the barrier to the risk level and the space available around the corner.

Available sizes:

• 350 × 650 mm
• 350 × 1150 mm
• 600 × 650 mm
• 600 × 1150 mm