Spray Can Holder for Perforated Panel R33

R33 spray can holder for clear vertical storage on a perforated panel

Frequently used cans have a habit of taking over a workbench. They are set down wherever there is space, moved during the next task and then searched for again. The R33 spray can holder gives one can or compatible bottle a defined place on a GWS or Sovella perforated panel. The container stays upright, visible and close to the point of use, while the work surface remains available for the job.

The holder has a 90 mm diameter steel cup with a height of 30 mm. It supports the lower section of the container without hiding most of the label. This makes it easier to identify the product before picking it up and to return it to the same place after use. The compact design is useful at workbenches, maintenance points, assembly stations and other industrial work areas where space needs to be used carefully.

Designed for GWS and Sovella perforated panels

The R33 perforated panel spray can holder fits the established GWS and Sovella pattern: 9 x 9 mm square holes with 38 mm centre-to-centre spacing. These dimensions are important. Although this type of product is also searched for as a pegboard spray can holder, pegboards and tool panels do not all use the same hole size or spacing. Confirm the panel specification before purchase rather than relying on the general pegboard name.

The holder uses the supplied mounting hardware to attach to a compatible panel. Once fitted, the spray can is stored above the work surface and does not occupy drawer or shelf space. If the workstation layout changes, the holder can be moved to another suitable position on the same compatible panel. This makes it easier to adapt storage when tools, tasks or material flows change.

Perforated panels may be installed above a workbench, on a workstation frame or on a suitable trolley. In every case, place the holder where the container can be reached without obstructing tools, controls or moving equipment. The panel itself must be installed and used according to its instructions and load limits.

Zinc-plated steel construction for workshop use

The R33 holder is made from zinc-plated steel. The protective surface supports regular use in industrial work areas and helps guard the steel against corrosion. Wipe away oil, cleaner or solvent promptly and follow the cleaning instructions for the substance involved. Chemical resistance can vary, so prolonged contact should be avoided unless compatibility has been confirmed.

Technical data